Related Product:
Solution:
Fixed:
1.EKI change to dhcp or bootp mode will pop-up "Invalid Parameter" message.
2.After EKI change to dhcp or bootp mode, the display information is not correct on Web GUI.
New Features:
1. Merge EKI-152xU-CE with EKI-152x-CE. if device support RS485 4-wire, the option will be shown on web config page.
2. Set RS485 4-wire mode through telnet & snmp(if supported)
Fixed:
model name with "I" or "CI" will not be displayed if platform support RS485 4-wire
Fixed:
Accessip is wrong after user setting DHCP by using Utility tool
New Features:
1. support Tx broadcast
2. Setting "sevice -> VCOM" Pages can switch VCOM 1.0 and VCOM 2.0. Setting is enable after rebooting. VCOM 2.0 mode is able to support running over TLS.
Fixed:
Wrong show on web system page, UTC-N and UTC+N are not same behavior.
New Features:
1. New USDG mode.
2. Web server support HTTPS.
Fixed: Memory corruption issue while setting NTP server larger than 63 bytes
Fixed:
CVE-2023-4202
CVE-2023-4203
New Features:
1. Firmware upgrade via HTTPS
2. Support SSDP
3. Recording function on Syslogd page
4. User Management for COM Port Service(Local/RADIUS/LDAP)
5. Check U-Boot MAC Address
Fixed:
1. Optimize Web Export Config Behavior
New Features:
1. Add Multicacst_TTL switch option for new USDG 2.0 UDP Mode
2. Add VCOM Supported: EV_BREAK
Thank you for your feedback
We will look over your massage and get back to you soon if you need further assistance!