The definition of the IRQ and Address for COM ports are fixed on PCM-5862.
COM1 3F8-3FF IRQ4
COM2 2F8-2FF IRQ3
COM3 3E8-3EF IRQ10
COM4 2E8-2EF IRQ5
The CMOS configuration provides a phycal swap function for two pares:
Port 1,2 swap COM1,2 and Port 3,4 swap COM 3,4.
As you swap ports, the IRQ follows is address. For example if I swap COM3 and
COM4 then my configuration becomes:
Port 4 = COM3 3E8-3EF IRQ10
Port 3 = COM4 2E8-2EF IRQ5
*** If you need to swap the IRQ definition only of COM3 and COM4 (Address
remain unchanged), Please swap hardware jumper of J8 and J9. Now this jumper
is only with 2 pins so rework these two jumper is necessary. After your
change J8 to 2-3 and J8 to 1-2, your hard ware configuration will be:
COM1 3F8-3FF IRQ4
COM2 2F8-2FF IRQ3
COM3 3E8-3EF IRQ5
COM4 2E8-2EF IRQ10
But note that CMOS will still show that 3E8 is still IRQ10 and 2E8 is still IRQ
5. In fact the IRQ is already swaped.
Thank you for your feedback
We will look over your massage and get back to you soon if you need further assistance!