How to setup TCP/IP and IPX for DOS?

Solution:

• How to setup TCP/IP and IPX for DOS?

  Prerequisite:
  Network Adapter
  Drivers for Packet Driver or ODI
  DOS TCP/IP application program (e.g. NCSA Telnet, FTP)
  
  Before you setup the software, please use the diagnostic program provided by
  vendor to setup the IRQ and IO address. Then test the Hardware to make sure it?
  s OK.
  
  There are two popular ways to achieve this, with Packet Driver or ODI Driver.
  
  I) Use Packet Driver
  If you just want to load TCP/IP and there is a Packet Driver for your Network
  Adapter.
  
  Example 1: PKT9008.COM for UM9008 Network Adapter
  
  >PKT9008.COM 0x60 0x5 0x300
  >REM Following is your TCP/IP Application
  >REM For example: NCSA TELNET
  >TELNET
  
  If you want to load two protocol, TCP/IP and IPX.
  
  Example 2:
  >PKT9008.COM 0x60 0x5 0x300
  >PKIPX.EXE
  >NETX.EXE
  
  II) Use ODI Driver
  If you want to load both IPX and TCP/IP, ODI (Open Datalink Interface) will be
  a good choice.
  (Following example use NE2000 compatible Network Adapter.)
  
  NET.BAT Sample:
  
  CD \NWCLIENT
  LH LSL
  LH NE2000
  LH IPXODI
  LH ODIPKT 0X60
  VLM /PS=OA /Mx
  F:
  LOGIN
  
  NET.CFG Sample
  
  Link Driver NE2000
  INT 5
  PORT 300
  FRAME ETHERNET_II
  FRAME ETHERNET_802.3
  PROTOCOL IPX 0 ETHERNET_802.3
  
  NetWare DOS Requester
  FIRST NETWORK DRIVE = F
  PREFERRED SERVER = OA
  NETWARE PROTOCOL = NDS BIND
  
  Protocol TCPIP
  ip_address 172.20.12.214
  ip_netmask 255.255.128.0
  ip_router 172.20.127.253
  UDP_Sockets 12
  TCP_Sockets 15
  
  MAM
  
  Link support
  buffers 5 1500
  max boards 4
  max stacks 4
  mempool 4096
  
  NCSA PC Telnet Information
  www.ncsa.uiuc.edu/SDG/Software/PCTelnet/