Modbus/TCP to RTU Bridge Setup
1) Network/IP Settings:
IP Address ................. 192.168.0.159
Default Gateway ............ 192.168.000.001
Netmask .................... 255.255.255.000
2) Serial & Mode Settings:
Protocol ................... Modbus/RTU,Slave(s) attached
Serial Interface ........... 9600,8,N,1,RS485
3) Modem/Configurable Pin Settings:
CP1 ...... RS485 Output Enable
CP2 ...... Not Used
CP3 ...... Not Used
4) Advanced Modbus Protocol settings:
Slave Addr/Unit Id Source .. Modbus/TCP header
Modbus Serial Broadcasts ... Enabled (Id=0 used as broadcast)
MB/TCP Exception Codes ..... No (no response if timeout or no slave)
Char, Message Timeout ...... 01000msec, 05000msec
Serial TX Delay ............ 0010msec
Thank you for your feedback
We will look over your massage and get back to you soon if you need further assistance!